Angle Grinder bracket with cable tidy?

[AdrianH]

This is something I did a little while ago, like quite a few I have a couple of angle grinders, one with a wire cup brush, one with a flap disc and one with a cutting disc fitted. To keep them neater when not in use I made a few of these holders from 2mm sheet.





Above is a jpg from my CAD program, it shows the basic idea, where the bends are and final shape.

I tended to group say four at a time and cut them out with my home made CNC plasma cutter, basic use of the flap disk to take the burrs off and then have a bit of fun with a home made press and basic tooling to get the shape.


A rather poor video really showing me with the press, but the job was the angle grinder holder, the two holes allow it to be mounted to the wall.

I really must get better at this video lark!.

Adrian

[DIYer]

Thanks AdrianH! We've added your Angle Grinder Bracket and Cable Tidy to our Storage and Organization category, as well as to your builder page: AdrianH's Homemade Tools. Your receipt:

Angle Grinder Bracket and Cable Tidy by AdrianH

tags: angle grinder