Vinni,
Thank you!
Dick
Printable View
Vinni,
Thank you!
Dick
Vinni,
Thank you and welcome to the forum.
old_toolmaker,
Thanks for additional photos, and explanations too. I better understand how it works. It looks quite easy to build, even with the helix angle, and It's also not too big to store.
Thanks again !
yves78,
I found three more pictures I had showing another part of my dividing attachment system. It is a dividing module that mounts to the cross slide and has it's spindle center line on the mini lathe center line. It can be used in two ways (1) for simple direct indexing using the lathe change gears and spring loaded detent (2) for compound indexing using the worm and hole plates from the spindle dividing head.
Thanks a lot, old_toolmaker.
Your builds are very clean !