Free 173 Best Homemade Tools eBook:  
Results 1 to 2 of 2

Thread: Lathe DC motor break

  1. #1

    Join Date
    Feb 2014
    Thanked 24 Times in 7 Posts

    glens5's Tools

    Lathe DC motor break

    This is a schematic of a DC break I made for the motor on my South Bend 9" lathe
    I used the parts I had on hand and it could be simplified with a 120 vac coil on relay 2 thus omitting transformer 1.
    I've been using this for a few years now and it works very well. The amount of breaking can be controlled with the resistance value between the bridge and the run winding of the motor. The time the DC is applied to the winding is controlled by an adjustable timer.
    I honestly think this is preferable to a mechanical break as it allows for manually positioning the chuck after the motor has stopped and the timer opens the contact supplying the DC to the motors run winding.Lathe DC motor break-brake8.jpg

    The resistor(s) were hand wound with nichrome wire salvaged from a heating element.

    I had originally experimented with charging a capacitor at line voltage and discharging it through a resistor.
    I found the 170 volts DC on the capacitor was too high and that the twenty volts or so through a full wave bridge and the .8 ohm resistor worked quite well. The timer only applies the DC for a couple of seconds.

    I should have mentioned this is with a run of the mill 1/2 HP single phase 120 vac motor with a separate start winding. The motor is reversed with a DPDT switch on the start winding and the break works in both directions.
    Last edited by glens5; 12-25-2018 at 07:20 PM.

  2. The Following 4 Users Say Thank You to glens5 For This Useful Post:

    Ken Koch (12-19-2018), NortonDommi (12-18-2018), Paul Jones (12-20-2018), PJs (12-20-2018)

  3. #2
    Content Editor DIYer's Avatar
    Join Date
    Aug 2013
    Thanked 886 Times in 817 Posts

    Thanks glens5! We've added your DC Motor Brake to our Lathes category,
    as well as to your builder page: glens5's Homemade Tools. Your receipt:

    Post your reply!
    Join 33,912 of us and get our 173 Must Read Homemade Tools eBook free.

    173 Must Read Homemade Tools

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts