Lathe Tool Bit Height setter using a micrometer head

[jjr2001]

This was one of the "I will get around to it" projects and I just got around to it.
Lots of tool height setters out there but not many allow you to measure the height so you can set the
tool a specific amount lower than center. The micrometer is set in place with it's set screw and set to a reading
on the barrel like 150 thou. If your bit was exactly on center height then 150 is now calibrated to your lathe center.

If you want to measure the difference of another tool just read the amount from 150 and you will know the difference.
Handy if you are not using a QCTP and need to put in a shim under your tool bit. Now you know exactly how thick
that shim needs to be to get you on center.

Cheers, JR

[ragsflh]

thanks for idea

[jjr2001]

Thank you Ragsflh, Glad you found the post useful. That is the best part of HMT, I am always finding
other ways to do something.

Cheers, JR

[DIYer]

Thanks jjr2001! We've added your Tool Bit Height Setter to our Measuring and Marking category,
as well as to your builder page: jjr2001's Homemade Tools. Your receipt:

Tool Bit Height Setter by jjr2001

tags: measurement