Free 173 Best Homemade Tools eBook:  
Remove advertisements
Results 1 to 2 of 2

Thread: Slide hammer bearing puller adapter

  1. #1
    Frank S's Avatar
    Join Date
    Aug 2015
    Location
    Peacock TX
    Posts
    2,900
    Thanks
    546
    Thanked 2,541 Times in 1,274 Posts

    Frank S's Tools

    Slide hammer bearing puller adapter

    I have a little 4 lb slapjack for pulling dents but I needed to remove an axle bearing from a Masda pickup rear end.
    My solution was to use my very old internal bearing puller and the slapjack the only thing was the hammer has a 1/2 13 thread while the puller uses a 5/8 1. I removed the push shaft from the puller then welded a pair of 1/2 13 nuts to a 5/8 11 bolt
    After welding 2 nuts together I ran a tap through them to make sure of no conflicting threads
    Slide hammer bearing puller adapter-20180714_200253.jpgc.jpg
    then welded the nuts to the bolt I ground it just enough to remove sharp edges
    Slide hammer bearing puller adapter-20180714_201109.jpgc.jpg
    Race removed
    Slide hammer bearing puller adapter-20180714_202618.jpgc.jpg
    Never try to tell me it can't be done
    When I have to paint I use http://kbs.justoldtrucks.com/

  2. The Following 3 Users Say Thank You to Frank S For This Useful Post:

    rossbotics (07-15-2018), Seedtick (07-16-2018), Toolmaker51 (07-17-2018)

  3. #2
    Content Editor DIYer's Avatar
    Join Date
    Aug 2013
    Posts
    3,090
    Thanks
    353
    Thanked 694 Times in 631 Posts


    Thanks Frank S! We've added your Slide Hammer Bearing Puller Adaptor to our Automotive category,
    as well as to your builder page: Frank S's Homemade Tools. Your receipt:





    Post your reply!
    Join 33,912 of us and get our 173 Must Read Homemade Tools eBook free.



    173 Must Read Homemade Tools

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •