2 piece milling vice

[Stevohdee]

For some square is not good enough. I picked up one of the pieces of a two piece manufactured vise like that and was going to make the solid end of the combo. I do not see any reason that would change very much if everything is hardened.
Very nice and clean job. I sure it will serve you well.
Nelson

Thanks nelson, tramming will confirm that the ol' eyes are still working ok and you havent missed a gap between the table and workpiece. I did tram a couple of times when i first made it and found was out by a country mile once so I used a torch and magnifyer, yep, I'm getting old. So your right, tramming should be done regardless if you wanna make sure
Cheers stevoh