User Tag List

Results 1 to 10 of 39

Thread: 4ft hydraulic plate roll

Jul 15, 2021, 09:35 PM #9

Frank S

Supporting Member

Join Date

Aug 2015

Location

Peacock TX

Posts

12,617

Thanks

2,677

Thanked 11,111 Times in 5,391 Posts

Frank S's Tools

Awards Showcase

Total Awards: 14

While working on a new repair project I decided that I was going to need to roll a couple strips of 3/8" thick 4 1/2" wide T1 steel Now the grade of the metal I have has a minimum yield of 100,000 PSI and a Brinell hardness of between 235 & 290 RC 26 in its natural state.
So a pretty good work out for my plate roll I figured. Actually due to there only being 9 inches total width the roll acted like it was no big deal.
This was one of the reasons why a built it like I did

These 2 strips would be about equal to a single piece 1/8" of hot rolled mild steel 54 inches wide

Last edited by Frank S; Jul 15, 2021 at 09:37 PM.

Never try to tell me it can't be done
When I have to paint I use KBS products

Reply With Quote
The Following 3 Users Say Thank You to Frank S For This Useful Post:

baja (Jul 17, 2021), NortonDommi (Jul 16, 2021), nova_robotics (Jul 16, 2021)