-
Balancing the Lathe.
Hello,
I have recently had to strip my lathe headstock down as there was a leak behind the front spindle bearing retainer. It was a good time to do a through clean and fit magnets in the oilways and scatter a few around the floor as well. While I had the spindle out I carved some lines in it, something I had been wanting to do for a while now.
Of course once I had the spindle set up on the mill I realised that I needed to make an engraving tool - for which I needed a lathe.........
After a coffee and a think I tried a Dormer BS 2 Centre Drill running at the max. mill speed of 1600 r.p.m. with a D.O.C. of 0.25 mm and I was quite happy with the result. The table stops were set for each length. First all the 10 degree marks followed by the 5 degree and then the 1 degree marks. I also carved a recess in the bearing retainer to make it easier to see the markings.
I still have a brake to make and will be looking at a disk brake off a Mountain bike which I will fit to the rear spider.
Still having a problem uploading pictures, probably due to resolution so I will put them in my dropbox and post a link later.
Back together and I checked the alignment while I was at it, all good.
Now what caused the leak? It was loose capscrews. I suppose I could have tightened them but if oil is coming past a gasket it needs a proper clean. Why did the screws come loose? An annoying vibration had developed at certain r.p.m. very small and I just hadn't had time to address it. Turns out it was my 5-Jaw chuck out of balance and when I weighed the jaws I had measurements of 635.2, 635.7, 635.8 & 640.6 grams and of course the lightest and heaviest were opposite each other. I think I had mixed them up sometime when swapping from external to internal gripping.
Turns out there is a very small imbalance in the chuck body as well.
That night I decided to have a look at YouTube and I think I may be being watched as one of the first things to pop up was a video on balancing a lathe chuck!
The two videos are posted below. This works and you do not need a 'smart 'phone' to do it either although I am sure that would help.
https://www.youtube.com/watch?v=HktQcm9tcu0
https://www.youtube.com/watch?v=repylWYf-8s
Quick, easy & effective.
-
-
-
Norton, this may be the answer to my issues! Excellent presentation, clear and precise explanations, and a cool cat! I am just looking for the application you used! Name or link would be appreciated! Thanks again!
-
Hi Rarmintrout,
I liked the videos as well, I don't have a 'smart 'phone' but found that I could just use a DTI against the headstock, didn't lift the lathe either.
The link to the on-line page is in the video description but here it is anyway:
https://www.emachineshop.com/dynamic...eel-balancing/
Super easy to use. I used a selection on Neodymium magnets bought On-line. Thinking about a dedicated spindle for mounting flywheels, mower blades etc.
