Printable View
Chip and dip bowl turned from a single chunk of wood.
Fullsize image: https://s3-us-west-1.amazonaws.com/h...l_fullsize.jpg
https://s3-us-west-1.amazonaws.com/h...p_dip_bowl.jpg
Previously:
https://www.homemadetools.net/forum/...500#post139285
https://www.homemadetools.net/forum/...679#post128728
https://www.homemadetools.net/forum/...3443#post78074
https://www.homemadetools.net/forum/...2588#post76628
https://www.homemadetools.net/forum/...0995#post73535
That would make a nice gift for someone.
I bet turning that chuck of wood sideways in the lathe is fairly nerve wracking, especially until it begins to balance out.
I'm confused. (OK, not a rare event.)
The concentric growth rings seem to imply that the bowl was spun about what would be the vertical axis of the trunk section. However, that wouldn't have left bark, if indeed that is what the dark stuff is, around the lip.
To get "bark" on the edge would require turning about what would be the horizontal axis of the trunk section.
Was the "bark" applied after the bowl was turned?