Free 173 Best Homemade Tools eBook:  
Become a founding member: 500+ tool plans, full site access, and more.

User Tag List

Results 1 to 3 of 3

Thread: Chip and dip bowl turned from a single chunk of wood - photo

  1. #1
    Content Editor
    Supporting Member
    Altair's Avatar
    Join Date
    Aug 2013
    Posts
    3,896
    Thanks
    845
    Thanked 9,455 Times in 2,813 Posts

    173 Best Homemade Tools eBook

  2. The Following 2 Users Say Thank You to Altair For This Useful Post:

    nova_robotics (May 14, 2021), Sleykin (May 14, 2021)

  3. #2
    Supporting Member mlochala's Avatar
    Join Date
    Nov 2012
    Posts
    264
    Thanks
    31
    Thanked 77 Times in 49 Posts

    mlochala's Tools
    That would make a nice gift for someone.

    I bet turning that chuck of wood sideways in the lathe is fairly nerve wracking, especially until it begins to balance out.

  4. #3
    Supporting Member mklotz's Avatar
    Join Date
    Aug 2015
    Location
    LA, CA, USA
    Posts
    2,630
    Thanks
    278
    Thanked 5,025 Times in 1,675 Posts

    mklotz's Tools
    I'm confused. (OK, not a rare event.)

    The concentric growth rings seem to imply that the bowl was spun about what would be the vertical axis of the trunk section. However, that wouldn't have left bark, if indeed that is what the dark stuff is, around the lip.

    To get "bark" on the edge would require turning about what would be the horizontal axis of the trunk section.

    Was the "bark" applied after the bowl was turned?



    173 Best Homemade Tools eBook
    ---
    Regards, Marv


    Home Shop Freeware
    http://www.myvirtualnetwork.com/mklotz

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •