Color your Pozis bronze

**PJs** · Nov 25, 2016, 09:53 AM

Great to know what that thread is, thanks. It was just a thought with no reconnoitering, but you Knew! I thought I remembered you posting the Dremel pin vise or similar. I have several chuck holders made over the years and generally keep several types of countersinks in them for general deburring. Also have a couple of double ended ones. Still need to make one for an old school half inch chuck I found at Restore for $1 and restored. They are also great for holding screws and such for grinding, sanding and wire wheeling small stuff.

Great Idea on the center drills...I've got a few that are dead in the bin. That Beam compass was/is Real Nice and a fair amount of work. Your link to Elmer's steam engine plans brought up a thought for further uses of these type components. On page 261 he shows how to cut a tapered keyway. Perhaps some of these could be used for the tool bit in his boring/broaching tool. Also like the way he set up the angle in the chuck with a pin...stored that in Memory bin 1832.

Thanks Much for what you bring to the forum!! Learn something every time! ~PJ