Drilling A Hole At an Angle

This simple addition to a small vise enables you to set it at an angle. By clamping the angled vise in a larger vise, you can drill holes at an angle.

If you are interested, please see

https://rick.sparber.org/DrillingHoleAtAngle.pdf


Your comments are welcome. All of us are smarter than any one of us.


Thanks,

Rick

I've seen "tangent bars" (the trigonometric cousin of the sine bar) that use the same principle. No need for a "stack" to get the proper height and the screw could be calibrated directly in degrees of inclination.

I have updated the article to show how I drill the hole without the drill bit bending.

https://rick.sparber.org/DrillingHoleAtAngle.pdf

Rick