er20 collet holder for the lathe

**Neil Jensen** · Aug 1, 2017, 02:03 PM

my 4 jaw wont chuck 1/2 inch or smaller,got tired of changing chucks so made this [bought the locking nut]

**NortonDommi** · Aug 2, 2017, 04:39 PM

An elegant solution to the problem.

**DIYer** · Aug 3, 2017, 07:03 AM

Thanks Neil Jensen! We've added your ER20 Collet Holder to our Machining category,
as well as to your builder page: Neil Jensen's Homemade Tools. Your receipt:

ER20 Collet Holder by Neil Jensen

tags: chuck, holder, collet

**ragsflh** · Aug 5, 2017, 07:35 AM

thanks. i need to do that

**Ralphxyz** · Mar 5, 2018, 06:57 PM

Why are you holding a piece of hex in a four jaw? Don't you have a 3 jaw?

Ralph

**Neil Jensen** · Mar 6, 2018, 06:56 AM

quicker to dial hex in than change chucks, I prefer the 4 jaw so seldom use 3 jaw

**Ralphxyz** · Mar 6, 2018, 08:19 AM

I would have just made the holder square. Of course you probably started with a hex piece.

Nice project, I'd be interested to see/read the steps you went through.

Ralph

**Neil Jensen** · Mar 6, 2018, 08:26 AM

I did make this one for the 3 jaw,after using it in the 4 jaw I did make one out of square stock for the 4 jaw. pretty simple build, just bored the bar out a little bigger than 1/2" turned diameter and threaded, bought the nuts from amazon about $5 each.