Helicopter rotor blades shattered by strong winds - GIF

Helicopter rotor blades shattered by strong winds.

<video controls autoplay loop> <source src="https://diqn32j8nouaz.cloudfront.net/helicopter_blades_broken_wind.mp4" type="video/mp4"> Your browser does not support the video tag. </video>


Previously:

https://www.homemadetools.net/forum/...013#post221090
https://www.homemadetools.net/forum/...200#post145824
https://www.homemadetools.net/forum/...524#post135942
https://www.homemadetools.net/forum/...568#post170295
https://www.homemadetools.net/forum/...944#post129552

So who would have thought this? The blades are made to wizz around at a high rate, but a cross wind just snaps them apart.

Quote:

---

Originally Posted by Fluffle-Valve

So who would have thought this? The blades are made to wizz around at a high rate, but a cross wind just snaps them apart.

---

It appears it was more than just a crosswind... suspect the blade encountered vertical/lifting wind when it rotated over the edge of the deck. The copter was just too close to the edge, and was susceptible to increased wind speed, caused by the deflection at the sides of the vessel. Same effect when semis get blown over by wind rising out of a ditch slope along a highway... happens frequently during windy months, along I-90, close to town.

Quote:

---

Originally Posted by Fluffle-Valve

So who would have thought this? The blades are made to wizz around at a high rate, but a cross wind just snaps them apart.

---

Spinning is what prevents them from snapping. Being composite (carbon fibre?) the things are probably brittle like spaghetti noodles, so much so that a bit of wind can cause them to buckle when stationary. Put a few tons of centrifugal force on each blade and keep them in tension, and all of a sudden they can tolerate 200-400 mph wind loads easily, plus the entire weight of a fully loaded helicopter.

Like pre-stressing concrete. Loading up concrete with additional force to keep it in compression actually makes it far, far stronger.