Free 173 Best Homemade Tools eBook:  
Become a founding member: 500+ tool plans, full site access, and more.

User Tag List

Results 1 to 2 of 2

Thread: Hex-Triangle Fixture for Rounds

  1. #1
    Supporting Member gatz's Avatar
    Join Date
    Feb 2016
    Posts
    75
    Thanks
    0
    Thanked 86 Times in 32 Posts
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    gatz's Tools

    Hex-Triangle Fixture for Rounds

    Occasionally I've had a need to mill 3 or 6 sides on some round piece.
    Always been a hassle to set the part for the 2nd and 3rd cuts.......keep fumbling around with 30-60-90 gauge, trying to hold all the stuff and tighten vise at the same time; got rather frustrating.
    The last need was for a drill extension. You all know how the chucks on cordless drills lack good holding power, so I wanted to mill 3 sides of a hardened 1/2-20 threaded rod that was to become the extension for a 13/16 4-flute drill.

    Finally made a fixture that allows indexing at 3 or 6 sides. These were made in pairs; dowel pins were fitted to the smaller holes to keep the 2 parts together while milling.
    Started with 2.25 round stock (happen to have some SS). Roughed out the center. Milled to 2" hex.
    Bored the opening by offsetting from zero. IIRC it was like + .035 in X and Y. Milled the "V". Drilled and tapped 5/16-18 holes for set screws.
    Some different size round pieces will require a different length set screw.
    Granted, when the fixture with the piece in place are rotated to the next index, the "touch-off" height will be different, but it's not a big deal.
    Attached Thumbnails Attached Thumbnails Hex-Triangle Fixture for Rounds-hex-triangle-fixture_1.jpg   Hex-Triangle Fixture for Rounds-hex-triangle-fixture_2.jpg   Hex-Triangle Fixture for Rounds-hex-triangle-fixture_3.jpg   Hex-Triangle Fixture for Rounds-hex-triangle-fixture_4.jpg   Hex-Triangle Fixture for Rounds-hex-triangle-fixture_5.jpg  

    Hex-Triangle Fixture for Rounds-13-16-drill-extension.jpg  

  2. The Following 3 Users Say Thank You to gatz For This Useful Post:

    Jon (07-30-2020), nova_robotics (07-30-2020), sossol (08-03-2020)

  3. #2
    Content Editor
    Supporting Member
    DIYer's Avatar
    Join Date
    Aug 2013
    Posts
    3,090
    Thanks
    562
    Thanked 1,344 Times in 1,211 Posts
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)


    Thanks gatz! We've added your Round Stock Holding Fixture to our Milling category,
    as well as to your builder page: gatz's Homemade Tools. Your receipt:





    Post your reply!
    Join 42,532 of us and get 500+ tool plans, tool eBooks, build guides, and much more.



    eBooks for Supporters

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •