High pressure pump and gauge for burst testing pipe - photo

High pressure pump and gauge for burst testing pipe.

Fullsize image: https://diqn32j8nouaz.cloudfront.net...p_fullsize.jpg

https://diqn32j8nouaz.cloudfront.net...test_setup.jpg


Previously:

https://www.homemadetools.net/forum/...824#post100116
https://www.homemadetools.net/forum/...697#post147846
https://www.homemadetools.net/forum/...512#post147198
https://www.homemadetools.net/forum/...505#post135848
https://www.homemadetools.net/forum/...841#post156283
https://www.homemadetools.net/forum/...101#post153568

Very similar to the Swagelok rig used to show Swagelok trainee's the differences between 1/4 and 3/8 stainless steel, of the same wall thickness, used in the basic bend and fitting test.

Didn't know Swagelok was rated to 30kpsi
That said, this setup doesn't look very complete.