Hollowers for Wood Turning

[PJs]

PJs,

Good to know and I thought snap technique would work (and even better after making a scribed line). The Dremel diamond cut off wheel should make this easier. I have a diamond wet saw for tile and brick work that might work without shattering the thin carbide if the carbide strip is tightly held and sandwiched in between two 1/2" thick wood boards. This works well for cutting very hard and thin Italian ceramic tiles.

Thanks, Paul

Good idea on the tile/brick saw...hadn't thought of that. I did have some concerns about creating stress fractures in the C2 by snapping it and it did create somewhat of a jagged edge but luckily left enough to grind down beyond those and to the Radii. Hopefully all moot now with the diamond Dremel wheel.

Thanks again. ~PJ