Homemade aluminum milling pallet - video

[Jon]

Homemade aluminum milling pallet. By R. Steven Lang. 13:43 video:

[mklotz]

Fourteen minutes of squaring a plate and drilling/tapping some holes in it. No fences or provision for same, no V-groove(s), no markers for preferred mounting orientation. What's next? Perhaps an hour long extravaganza on how to use strike anywhere matches?

[high-side]

Fourteen minutes of squaring a plate and drilling/tapping some holes in it. No fences or provision for same, no V-groove(s), no markers for preferred mounting orientation. What's next? Perhaps an hour long extravaganza on how to use strike anywhere matches?

I was thinking along them lines. How about a 15 minute video on how to sweep up all the chips?

[dagrizz]

Gentlemen, however narrow the target audience might be, there's no call for denigrating comments. you might, instead, investigate his other YouTube offerings before forming your opinions.

[NeiljohnUK]

Looks similar to my off-cut optical breadboard, everyones got to start somewhere.

[high-side]

Gentlemen, however narrow the target audience might be, there's no call for denigrating comments. you might, instead, investigate his other YouTube offerings before forming your opinions.

My apologizes.

[Scotsman Hosie]

Sorry – I couldn't stay for the whole thing.