https://youtu.be/D9oX5Yu01h0
Printable View
<!-- BEGIN /var/www/html/homemadetools/protected/modules/zeus/views/tool/postUpdate.php -->
Thanks Retro Steam Tech! We've added your Tap Handle to our Tapping and Threading category,
as well as to your builder page: Retro Steam Tech's Homemade Tools. Your receipt:
<div id="blocks"> <div class="block b1 pngfix"> <div class="bimg"> <div> <a href="https://www.homemadetools.net/homemade-tap-handle-11"> <img src="/uploads/250032/homemade-tap-handle-11.jpeg"/> </a> </div> </div> <div class="head pngfix"></div> <div class="left pngfix"></div> <div class="right pngfix"></div> <div class="blockover b1 pngfix"> <div class="title"> <a href="https://www.homemadetools.net/homemade-tap-handle-11">Tap Handle</a> <span> by <a href="https://www.homemadetools.net/builder/Retro+Steam+Tech">Retro Steam Tech</a></span> </div> <div class="tags">tags: <a href='https://www.homemadetools.net/tag/handle'>handle</a>, <a href='https://www.homemadetools.net/tag/tapping'>tapping</a> </div> </div> </div> </div>
<!-- END /var/www/html/homemadetools/protected/modules/zeus/views/tool/postUpdate.php -->
Why go to all that bother when this little thingy does the job very adequately, it can even take a few different sized very small taps as well. Make sure that you get one of them that has 4 jaws to grip the taps correctly. It even has a swivel on the top, so you can hold it with one finger to keep it upright, this stops the tap from trying to start at crazy angles and breaking the very small taps. :-)
https://www.ebay.com.au/itm/16469394...QAAOSwsxxgImuN
Because the name of the website isn't "Howtobuytools.net"
So the cost of machining such a stupid thing still outweighs the cheap cost of buying it, some times " stupid" seems to shine around here.
Greenie, the tool featured in this thread, and the tool you linked, are nothing alike.
The tool you show has a very small diameter and will be very hard to apply much toque to in turning a tap. The featured tool is a larger diameter knob, knurled to give a good grip.
If you're going to make tap wrenches for small taps, you're well advised to incorporate a guide pin into the design. Without one, it's just too easy to bend the delicate tap and snap it. In my article on the subject...
https://www.homemadetools.net/forum/tap-holders-26298
I point out that, at least here in the USA, the tiny taps have the same size shank, and so a single hole and a setscrew is all that's needed to secure them. For odd size shanks, I show several other designs including one with collets of a sort.
Ain't nobody with a hobby machine shop anywhere close to breaking even anyway.
No different than golfing, fishing, drinkin' or chasing women, it's all just a big damn waste of time and effort......... just stupid ........ unless it was fun enough to do it again next week.