Plane lands with jammed nose gear - GIF

[Altair]

JetBlue Flight 292 lands with jammed nose gear at Los Angeles International Airport on September 21, 2005.




Previously:

Attack aircraft loses landing gear wheel while landing on carrier - GIF
https://www.homemadetools.net/forum/...531#post182106
Fixing a broken landing gear midair - GIF
Biplane rips off landing gear on touchdown - GIF
MiG-29 prematurely retracts landing gear on takeoff - GIF
Douglas A-20 Havoc belly landing - GIF
Plane landing turns into plane drifting - GIF

[Frank S]

Ladies and gentlemen this is your captain speaking. I have been informed there will be a slight delay in our continuing flight. due to routine FAA safety inspection of the plane's forward landing gear

[Karl_H]

I would like to hear the conversations between Air Traffic Control and the Pilot - I'll bet they are all cool as cucumbers!

[mklotz]

If I were the pilot I would hunt down the airplane designer who designed a nose wheel that could rotate to that position and do something to him that could be pled down to attempted manslaughter when my case comes to court.

[Frank S]

If I were the pilot I would hunt down the airplane designer who designed a nose wheel that could rotate to that position and do something to him that could be pled down to attempted manslaughter when my case comes to court.

When you think about it all nose wheels have to be able to rotate 90° in either direction for when the aircrafts steers into or away from the gates.
Due to the diameter of the tires many if not most large passenger planes have to rotate the wheels to the 90° position in order for them to have enough room under the belly of the plane to be stowed away.
It seems a stupid idea to me though since the nose wheels are locked in the forward position on take off why not shift some of the internal stuff one way or the other to allow them to remain in the forward locked position.
Looks to me like a simple enough solution, just make them to operate much like the parking brakes do on a semi. but instead to linier motion of the spring brake and air application chamber rotating an S cam shaft make it pure linier with a wide tapered key to fit in a tapered slot.
It would require pressure to release the lock which could only be applied when there was weight on the strut and could not be unlocked after take off.
But the gear setups that give me the willies are the main gear that go through a number of gyrations to fold for storage