Excellent video. I was watching on a cell phone and AT&T would cause the video to freeze every couple of minutes - I wanted to scream. This only seems to happen on the really good videos.

In any event a little advice on drilling stainless:
1. Keep the spindle speed low, at least half of what you might use in steel.
2. Never allow the drill to rub.
3. Use a good cutting oil. WD 40 doesn’t cut it in stainless.

Having had my share of problems working stainless steel the above are hard earned guidelines.


In any event this video has stirred an interest in engraving. Well done!