Real interesting site. Glad I found it.

I came across this site when looking for info on parting off titanium to make suppressor baffles. Real good info.
The first time I tried to use the same type of parting tool on a 1.375 G5 titanium bar the insert wanted to drift to the right and starting to cut at an angle. I will try again using the info from this site.

Hi mdei1961 - welcome to HomemadeTools.net :welcome:

Sounds like you'll fit in well here :)

Also, this link is a good source for ideas: Homemade Firearm and Weaponry Tools - HomemadeTools.net

This may help too: https://www.homemadetools.net/forum/...k-baffle-39185