Rockwell/Delta wood lathe

[zetuskid]

i went to this site lathes.co what it said was the 14 X 36 rockwell used a threaded 1" X8 thd RH on the inboard and a 1" X8 thd LH on the outboard end, i would start with a 1" x8 left hand nut to make my bowl turning faceplate, buck it underlined it and wiped out half of the site so here it is again lathes.co forward slashdennorske fwd slash page3 dot html buck

Thank you so much Buck. That explains a lot. Thanks for your follow-up and research. I just knew you guys would come through.

[buck]

YVW,, primarily i was a machinist/millwright,, gas and steam turbine millwright, but all machines interest me, soooo, anytime buck