Printable View
Scythe peening tool.
<video controls autoplay loop> <source src="https://s3-us-west-1.amazonaws.com/hmt-forum/scythe_peening_tool.mp4" type="video/mp4"> Your browser does not support the video tag. </video>
Previously:
https://www.homemadetools.net/forum/...3352#post98829
https://www.homemadetools.net/forum/...596#post155378
https://www.homemadetools.net/forum/...475#post154867
The channel. Is the channel in order to channel dust and bits from the cutting edge out the tip?
The channel at about the 30 sec mark is a result of the tool profiles on the blade. It is not functional. Use of the tool is optional for peening, it is commonly done freehand with a hammer and small anvil. If lacking experience as to where to hammer, the tool helps you move just the right amount of metal to get a razor thin edge. Two tools are often used (notice he has 2 in his hand at the start), a bigger one to rough in the shape and then a smaller one to refine the edge. This also results in a 'channel' of 2 parallel lines.