shaper tool holder part 1

[Okapi]

The tools I've seen are old fabrication, and not always in metric, on my shaper I'm using 12mm. wide tools, and my holder is made for a 6mm steel bar used especially for inner angles.

[NortonDommi]

The tools I've seen are old fabrication, and not always in metric, on my shaper I'm using 12mm. wide tools, and my holder is made for a 6mm steel bar used especially for inner angles.

You have a Metrickery shaper?

[Okapi]

Yes, it's an Atlas if I compare to what I can found on the web etc. but made with 1/100mm scales and metric screws, the number plates and all is like the inches version, but in metric units, as I understand this tool, it was made for a precision use, with a repeatability of a 1/100mm.
http://www.lecollectionneur.ch/rapid...-dun-etau.html

http://www.lecollectionneur.ch/rapide-lime/