Mini Lathe Treadmill Motor Conversion, Episode 3 up Now.

[The Aussie Shed]

Episode 3 up Now, hope you like it.
Cheers.

[Eaglewood]

Hi Aussie, nice conversion,very professional. I have converted my 10 inch lathe to treadmill and am in the process of converting a metal bandsaw.I have tried using a cheap scr and bridge rectifier but could not get a clean signal-brushes arced. I have used a control from KB but very expensive. Couldn’t catch your link to the control you used can you enlighten me?
Thanks
Dick

[DIYer]

Thanks The Aussie Shed! We've added your Mini Lathe Motor to our Lathes category,
as well as to your builder page: The Aussie Shed's Homemade Tools. Your receipt:

Mini Lathe Motor by The Aussie Shed

tags: lathe, motor

[vortexwizard]

you could try adding smoothing capacitor and bleed down resistor after the rectomfrier to clean up the dc