Today I needed to polish the outside of a tube that was longer than any of my lathes currently under power.
Since I only required a low RPM and was not turning it down the logical choice was the smallest lathe in my shop the 12/36 Atlas/Craftsman mostly because it is situated near my drill press and I could use the vice on it as my tail stock.
Never try to tell me it can't be done
When I have to paint I use KBS products
drivermark (Dec 7, 2021), mwmkravchenko (Dec 8, 2021), old_toolmaker (Dec 12, 2021)
Thanks Frank S! We've added your Lathe Rest Extension to our Lathe Accessories category,
as well as to your builder page: Frank S's Homemade Tools. Your receipt:
Desperation is the Mother of a lot of inventions some of them good to!Originally Posted by Frank S
Today I needed to polish the outside of a tube that was longer than any of my lathes currently under power.
Since I only required a low RPM and was not turning it down the logical choice was the smallest lathe in my shop the 12/36 Atlas/Craftsman mostly because it is situated near my drill press and I could use the vice on it as my tail stock.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
LinkBack URL
About LinkBacks
Reply With Quote
Bookmarks