Stops for the Sieg SX2.7

[editor@glue-it.com]

I've made some hard stops for the Sieg milling machine. These use the T-slot in the front of the table.

Up until now I've been using engineers clamps when I need a hard stop, these work very well.



However, with the T-slot in the front of the table this is crying out for a better solution

[Karl_H]

My version for the Taig Mill



The fixed rectangular block in the middle has been replaced with a cylinder to minimize contact area and increase accuracy. It screws into an existing threaded hole on the mill.

[NortonDommi]

If the slot is there it is surprising that it did not come equipped.

[Karl_H]

If the slot is there it is surprising that it did not come equipped.

The Taig mill and lathe come with all sorts of T-slots and dovetails for user add-ons. The price is kept low by having the user build what he needs, rather than buying what the average user might want.