New plans added on 11/01: Click here for 2,541 plans for homemade tools.
KustomsbyKent (Jan 21, 2024), mr mikey (Jan 19, 2024), nova_robotics (Jan 18, 2024), tuchie (Jan 18, 2024)
There is a much easier way to pull that forklift out of the ditch,
I had a similar event involving a forklift that had backed into a pipeline trench, at an angle steeper than the one in the video. We used my 14,000lb welding rig to pull it out. 10 sp. road ranger transmission small V8 cat engine. Transmission in low, chain around the goose neck ball, forks about a foot off the ground, chain around the mast about 5 feet up from the ground Eased out on the clutch just above an idle. By hooking the chain higher up this raised the rear of the forklift up while pulling down on the drive tires. Pulled it out first time with no problems.
These guys should have had a drawbar on the lift arms with the arms raised and the chain on the forklift much higher up but the forks down low
Never try to tell me it can't be done
When I have to paint I use KBS products
baja (Jan 23, 2024), emu roo (Jan 22, 2024), nova_robotics (Jan 22, 2024)
mr mikey (Jan 23, 2024), nova_robotics (Jan 22, 2024)
WmRMeyers (Jan 21, 2024)
tonyfoale (Jan 26, 2024)
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks