Free 173 Best Homemade Tools eBook:  
Remove advertisements
Results 1 to 2 of 2

Thread: Dial Gauge mount for Chuck

  1. #1
    garage nut's Avatar
    Join Date
    Jul 2017
    Location
    Port Elizabet, SA
    Posts
    144
    Thanks
    48
    Thanked 133 Times in 50 Posts

    garage nut's Tools

    Dial Gauge mount for Chuck

    Had to square up my new milling machine vice.Had a dial gauge I used to set the vernier pulleys for my race car, but no magnetic base.
    So whipped out this little adapter that goes around a 8mm drill that goes into the chuck and then you can run the dial against a parallel clamped in the vice.
    Attached Thumbnails Attached Thumbnails Dial Gauge mount for Chuck-adapter-dial-gauge.jpg  

  2. The Following 2 Users Say Thank You to garage nut For This Useful Post:

    bgerens (10-14-2017), Seedtick (10-14-2017)

  3. #2
    Content Editor DIYer's Avatar
    Join Date
    Aug 2013
    Posts
    3,087
    Thanks
    339
    Thanked 667 Times in 605 Posts


    Thanks garage nut! We've added your Dial Gauge Chuck Mount to our Measuring and Marking category,
    as well as to your builder page: garage nut's Homemade Tools. Your receipt:





    Post your reply!
    Join 33,912 of us and get our 173 Must Read Homemade Tools eBook free.



    173 Must Read Homemade Tools

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •