7 Attachment(s)
Threading Insert Tool Holder
I made this tool holder for holding a TNMC43NV carbide threading insert. The insert measures .187" thick with an I.C. of .500", it has a .200" diameter hole which is countersunk from both sides.This tool holder was machined on both sides to accept the insert on either or, With the ability to place the insert on either side of the tool lets me work closer to the chuck or closer to the tail stock of the lathe.
The tool was made from 0-1 steel, hardened, tempered, and ground all over,
Below are some photos
Thanks For Looking
And Happy Machining
Doug
Click here to purchase a set of these plans http://www.homemadetools.net/forum/t...l-holder-50378
Attachment 3100
Above shows the milling of the triangular seat
Attachment 3101
Above shows tapping the 5mm x .08 hole for holding the insert
Attachment 3102
Above shows the front view of the tool
Attachment 3103
Above shows a side view of the tool
Attachment 3104
Above shows another side view of the tool
Attachment 3105
Above shows the insert in it's seat
Attachment 3106
Above shows another view of the insert in it's seat
Click here to purchase a set of these plans http://www.homemadetools.net/forum/t...l-holder-50378