User Tag List

Results 1 to 10 of 15

Thread: Bubble Level Attachment For T-handle Tap Wrench

Jun 26, 2018, 09:02 PM #10

saintrain

Join Date

Jun 2018

Posts

12

Thanks

77

Thanked 14 Times in 4 Posts

Awards Showcase

Total Awards: 1

Thanks @Paul Jones!
Great tip! Just added a bullseye to my drill. (These pix are a re-staging since I'm using the bubble so much. I thought I'd share.)

First pic shows "milling" a "flat". Chucked a 3/8" (headless) bolt into drill chuck and 3-jaw mounted to the tailstock of my shopsmith 10ER. Used a re-purposed 3/4" spade bit as the end mill.

REALLY should have shortened the shank! As there was a little chatter there were a few candidates for the desired flat. :-) I reused the setup to find the optimal one.

I set the 3-jaw on my bench with another bullseye on the face and matched the one on the drill to it as I epoxied.

Doug

Last edited by saintrain; Jun 26, 2018 at 09:06 PM.

Reply With Quote
The Following 7 Users Say Thank You to saintrain For This Useful Post:

Home-PC (Aug 6, 2020), Jon (Jun 27, 2018), NortonDommi (Jun 27, 2018), Paul Jones (Jun 28, 2018), PJs (Jun 30, 2018), rlm98253 (Jun 28, 2018), Sleykin (Jun 28, 2018)