Bubble level - video

**Jon** · Feb 13, 2020, 09:31 AM

Bubble level. By EL METAL RaymondMenendez. 14:01 video:

Previously:

Homemade lifting and clamping jaws - video
Homemade machine vise - video
Homemade low-profile side clamps - video
Watchmaker's anvil - video

**wizard69** · Feb 15, 2020, 01:02 PM

Nice work!

I’m surprised that the drill bit didn’t try to corkscrew in when doing the countersinks. That made me nervous.

**Toolmaker51** · Jan 1, 2021, 09:24 PM

I was relieved at the end; when means to adjust proper level became evident.
Most any clean, generally level surface can be used to trim a level in. Mark an area with tape, or fence of some manner to repeat placement as progressing along. Then turn subject level around end for end to verify. Any deviation must read the same, regardless orientation.
Same method purchasing a level. Perch selected level on 2 as similar blocks possible right on the stores floor, and read. Reverse as described above.