Building a brake line bending fixture.
I am finally back working on my Astro van project, getting some of the brake plumbing done. I swapped out the stock prop valve for a Wilwood piece and had to reconnect the master to the valve.
http://images41.fotki.com/v1634/phot...MVC022F-vi.jpg
This was a bit of an adventure getting the tight bends that were needed to run the lines.
I ended up making a little bending fixture to get it done. This will be pretty handy for doing the rest of the van.
http://images34.fotki.com/v1633/phot...MVC023F-vi.jpg
I made the clamp block on the mill. Both ends have their uses and I used both getting the bends into the lines.
http://images41.fotki.com/v1634/phot...MVC016F-vi.jpg
http://images52.fotki.com/v1639/phot...MVC017F-vi.jpg
Continued in next post.