DIY Sliding Table Saw part1

[Metalgeria]

[that_other_guy]

Metalgeria,

I really appreciate that
1) your video does NOT start with way too loud and over the top intro music and sound affects,
2) your video is NOT full of over-bearing, too loud music thru out,
3) with few and simple tools you make a complex and useful tool,
4) great skills; your welds are much better than most you-tubers!
5) more great skills; you obviously know how to minimize heat warp

Well done!
I am looking forward to part 2.

It looks like there are a lot of interesting things happening in that shop (plasma cutting, scroll bending, etc.)

Thanks for sharing it!
Brian

[Metalgeria]

Thank you very much for your support, i'm really an amator with 18 mounts of experiance

[ranald]

Before I viewed this, I wondered about the bearings clashing with crud: you have that covered. Thanks