Jul 21, 2016, 05:56 PM
Folding Out-Feed Table for a Portable Table Saw
This table was made to be portable and used mainly on commercial job sites for ripping cement fibre siding products. Mainly full sheets of panel for cladding beams and posts.
The large surface provides excellent support for the material as it is fed through the saw.
The folding legs were too narrow and short as is so 2x4s were attached by pre drilling holes through the brackets and into the 2x4s which are splayed at an angle for a wider stance.
Check out the video:
The Following User Says Thank You to Keith William Knull For This Useful Post:
Jul 24, 2016, 01:49 AM
Thanks Keith William Knull! We've added your Folding Outfeed Table to our Outfeed Tables category,
as well as to your builder page: Keith William Knull's Homemade Tools. Your receipt:
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Tags for this Thread
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts