Homemade aluminum milling pallet - video

**Jon** · Mar 12, 2020, 03:18 PM

Homemade aluminum milling pallet. By R. Steven Lang. 13:43 video:

**mklotz** · Mar 12, 2020, 04:18 PM

Fourteen minutes of squaring a plate and drilling/tapping some holes in it. No fences or provision for same, no V-groove(s), no markers for preferred mounting orientation. What's next? Perhaps an hour long extravaganza on how to use strike anywhere matches?

**high-side** · Mar 12, 2020, 07:49 PM

Originally Posted by mklotz

Fourteen minutes of squaring a plate and drilling/tapping some holes in it. No fences or provision for same, no V-groove(s), no markers for preferred mounting orientation. What's next? Perhaps an hour long extravaganza on how to use strike anywhere matches?

I was thinking along them lines. How about a 15 minute video on how to sweep up all the chips?

**dagrizz** · Mar 13, 2020, 12:27 AM

Gentlemen, however narrow the target audience might be, there's no call for denigrating comments. you might, instead, investigate his other YouTube offerings before forming your opinions.

**high-side** · Mar 14, 2020, 09:29 AM

Originally Posted by dagrizz

Gentlemen, however narrow the target audience might be, there's no call for denigrating comments. you might, instead, investigate his other YouTube offerings before forming your opinions.

My apologizes.