A Layout Punch Guide

[JoeH]

It is easy to find the intersection of two scribed lines with a layout punch if the lines are deep enough to feel. Here is a solution when you must not cut into the stock.

If you are interested, please, click here.

If you want me to contact you each time I publish an article, email me with "Subscribe" in the subject line. In the body of the email, please tell me if you are interested in metalworking, software plus electronics, kayaking, and/or the Lectric XP eBike so I can put you on the right distribution list.

If you are on a list and have had enough, email me "Unsubscribe" in the subject line. No hard feelings.


Your comments are welcome. All of us are smarter than any one of us.


Thanks,

Rick

Just curious about the aluminum coil. Was that supposed to be foil? Aluminum flashing? Interesting idea. I could see expanding it to make a template if I had several holes to lay out on multiple pieces. Thanks.