I find that it is difficult to even use the full diameter of the table and so I've made longer T-nuts
The benefit is the support studs for the clamps can then be positioned outside the diameter of the table, gaining precious mm.
Full article on these: Longer T-nuts – Warco HV4 4″ / 100mm Rotary Table – glue-it.com
EnginePaul (Mar 4, 2018)
Double T nuts are very handy for just that I've had some that I've made for years
http://www.homemadetools.net/forum/d...6086#post65895
Never try to tell me it can't be done
When I have to paint I use KBS products
EnginePaul (Mar 4, 2018)
Great idea
What timing, I've just started making my own set of T nuts for the first time. My mill table isn't very deep, so some extra long would be very handy to have around. Thank you very much for providing the inspiration
It's not the destination but the journey you take to get there that matters.
The thing to be careful about is over stressing the "T" slots very easy to do with extended "T" nuts
Never try to tell me it can't be done
When I have to paint I use KBS products
Thanks editor@glue-it.com! We've added your Long T Nuts to our Workholding category,
as well as to your builder page: editor@glue-it.com's Homemade Tools. Your receipt:
Thanks Canobi! We've added your Long T Nut to our Workholding category,
as well as to your builder page: Canobi's Homemade Tools. Your receipt:
Long T Nut by Canobi
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
LinkBack URL
About LinkBacks
Reply With Quote
Bookmarks