Need Your Help: Need to Design a Saw with SUPER LOW KERF LOSS

Quote:

---

Originally Posted by Frank S

I am wondering if a press mold cold not be made heated to somewhere in the 550 to 600° f range. then a small pellet of the material be placed in the shaped mold cavity the punch of the same shape be pressed down on the heated pellet to a high enough pressure to for the desired product.
It seems that vespel can be injection molded with very little chemical alteration

---

Frank, interesting thought. But good luck getting DuPont to sell you that pellet. The better bet is to wait for 3D printing, which will be here sooner than anyone thinks.

EG

E G you might think about Torlon® or Flourosint® as alternatives probably not any more readily available

Quote:

---

Originally Posted by Frank S

E G you might think about Torlon® or Flourosint® as alternatives probably not any more readily available

---

I'm actually aware of those two materials. The cool thing is there are literally more than a hundred industrial plastics that have never been made into guitar picks by ANYONE.

thanks!