close...
http://electronicsam.com/images/gree...422_190242.jpg
Printable View
I think it works better....
http://electronicsam.com/images/gree...426_112519.jpg
I think I get a D for effort...
https://youtu.be/a7CO9gohaXE
http://electronicsam.com/images/gree...428_191604.jpg
Does the material make a difference? Really nice, thank you for posting.
Ralph
I do actually talk at about 6:30m
https://www.youtube.com/watch?v=PtD9w6lp8n8
I sure love seeing it cut, what motors and drivers do you have with your CNC?
This is a tormach 440 sized mill I got for doing some work. (it was literally tormach's prototype. Thank goodness they didn't go with this supplier..) It had a lot of fit and finish issues.
So the steppers are what would be on the 440 and a leadshine mx3660 runs them. The spindle is a 750w iirc brushless that I am running with a stmbl drive. (open source swiss army knife of servo drives)
https://www.youtube.com/watch?v=n2BGYOcmC4w
Thanks! I have a riser for my 8520 on my todo list. Besides motorized XYZ.
Ralph