Free 186 More Best Homemade Tools eBook:  
Get 2,000+ tool plans, full site access, and more.

User Tag List

Results 1 to 2 of 2

Thread: Pipe wrench - video

  1. #1
    Jon
    Jon is online now Jon has agreed the Seller's Terms of Service
    Administrator
    Supporting Member
    Jon's Avatar
    Join Date
    Jan 2012
    Location
    Colorado, USA
    Posts
    25,451
    Thanks
    7,928
    Thanked 38,621 Times in 11,284 Posts

    Pipe wrench - video

    Pipe wrench. By RELIETRON. 3:47 video:


    186 More Best Homemade Tools eBook

  2. #2
    Supporting Member Toolmaker51's Avatar
    Join Date
    Feb 2016
    Location
    Midwest USA
    Posts
    5,330
    Thanks
    7,041
    Thanked 2,977 Times in 1,892 Posts

    Toolmaker51's Tools
    "Make a Strong Pipe Wrench"
    ?
    0'.05" in, a Grade III bolt.
    At 0'.25" fully half the engagement diameter is ground away; not flat, or parallel in either plane.
    At 0'.40" notch for the adjustment nut; not parallel seat for nut, nor allowance for thrust washer.
    By 0'.42" prepping to weld the handle. Instead of this being one piece, that and lower jaw are welded not only at narrowest cross section, but where the strain of torquing is highest.
    Now, 1'.36" two cheek pieces welded on, on top of handle weld, instead of overlapping.
    Of course, here in 2'.40" threaded portion attached to upper jaw, again at narrow juncture.
    My favorite, 2'.55" and countering industry standard of sharp milled teeth; angle grinder and narrow cut off wheel.
    Maybe intended only for threaded copper, garish internet paint step eliminates potential hardening of said teeth.
    Closing seconds of vid, it's demonstrated on a nut and bolt, IIRC are straight threads, not taper of pipe with increasing force needed to drive a tight joint.

    Right in step with trendy adoptive identities, a filmy shadow of a pipe wrench, but terrific paperweight.

    2000 Tool Plans
    Sincerely,
    Toolmaker51
    ...we'll learn more by wandering than searching...

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •