Scooter Stand

[remedyman]

I have a small business working on scooters. As well as working on a couple that are in the family. Bending over or crawling on the ground to look at low pieces has been causing my back to hurt so I decided to do something about it.

I took a bunch of angle iron and built a stand. Then I took some scrap angle iron from bed frames to build the ramp. It is nice having the scooters up so high in the air but there are times when it is too tall. I am going to work on a method that will allow me to raise and lower it one to two feet.

I hope to get some feed back on this and see if there is room for improvement. Also, this is my first pure welding project.