User Tag List

Results 11 to 14 of 14

Thread: small boring bar holder

May 25, 2021, 01:48 AM #1

Frank S

Supporting Member

Join Date

Aug 2015

Location

Peacock TX

Posts

12,611

Thanks

2,677

Thanked 11,100 Times in 5,384 Posts

Frank S's Tools

Awards Showcase

Total Awards: 14

small boring bar holder

I needed a holder for a 3/8" shank boring bar. The logical choice was a scrap cemented cutter by drilling a hole in the end to the depth of length of the boring bar shank, then cross drilling and tapping for a standard 3/8" flat point grub screw

I can always silver solder a new carbide on the 5/8" square

300+ new builds daily: cars, trucks, bikes, fabrication → BuildThreads.com

Never try to tell me it can't be done
When I have to paint I use KBS products

Reply With Quote
The Following 11 Users Say Thank You to Frank S For This Useful Post:

baja (May 30, 2021), Home-PC (Aug 9, 2022), Jon (May 28, 2021), LMMasterMariner (Jun 4, 2021), metric_taper (May 25, 2021), NortonDommi (May 25, 2021), Paul Jones (May 26, 2021), rebuilder1954 (May 26, 2021), Scotty1 (May 25, 2021), stillldoinit (May 26, 2021), Toolmaker51 (May 26, 2021)