Small Plastic Part Fabrication Using Copper Wire

[rgsparber]

So many expensive products are made from tiny, weak pieces. Such is the case for my water-resistant MP3 player. There was no way I was going to toss this device just because a critical support arm failed. Fabricating a new part that was stronger than the original turned out to be easy. I just needed an inch of copper wire.

If you are interested, please see

https://rick.sparber.org/SmallPlasti...abrication.pdf


Your comments are welcome. All of us are smarter than any one of us.


Thanks,

Rick

[DIYer]

Thanks rgsparber! We've added your Small Plastic Part Repair to our Miscellaneous category,
as well as to your builder page: rgsparber's Homemade Tools. Your receipt:

Small Plastic Part Repair by rgsparber

tags: plastic, repair