T-nuts - video

[Toolmaker51]

So, many minutes describing non T-nut activity and apparently private CNC just mills steps? I sure didn't spend 21 minutes learning T-nut theory; scanned the time line and 30-40 seconds of video. Sorry, Casual Haze didn't win this subscriber.
Why on earth would they be milled jointly; then sawn, and drill/ tap individually? Wouldn't a tapped hole and screw be a spiffy reference stop?
A ton of jokers think CNC is the living end, be-all end all, and yet lack concepts of logical processing.

Proud handle crankers, hands up!

Pitting one against another, and even first 5 minutes here; https://www.homemadetools.net/forum/...857#post198840