Tool Rack for Lathe Tailstock Tooling

Shown is a small 18" X 5" lathe tailstock tool rack made from 3/4" red oak and finished with two coats of polyurethane spray finish. The rack is attached to wall near the rear of the lathe and allows for easy access to the various tools that fit into the tailstock. The rack can hold 11 tools in evenly spaced and staggered holes of 5/8" dia. in the front row and 1" dia. in the back row. The holes were drilled on a drill press using forstner drill bits. All the various tools shown in these photos use MT2 Morse Taper adapters. The MT2 adapters have been shortened in length to allow the lathe tailstock to fully retract to a zero setting without accidentally ejecting the tools.

Organization is the soul of business ... Very good Paul ...

:clapping:

Nice rack, and good use of available space.

Hi Paul,
very nice, that's a deluxe shelf, it's useful and beautiful !

Christophe

Thanks for all the feedback. These are my "feel good" projects around my shop that keep things organized and I can see what is available for the task at hand.

Thanks Paul! I've added your Tool Rack to our Storage and Organization and Woodworking categories, as well as to your builder page: Paul Jones' Homemade Tools. Your receipt:

<div id="blocks"> <div class="block b1 pngfix"> <div class="bimg"> <div> <a href="/tool-rack-5"><img src="/uploads/104181/tool-rack-5.jpeg" alt="Tool Rack" /></a> </div> </div> <div class="head pngfix"></div> <div class="left pngfix"></div> <div class="right pngfix"></div> <div class="blockover b1 pngfix"> <div class="title"> <a href="/tool-rack-5">Tool Rack</a> <span> by <a href="/builder/Paul+Jones">Paul Jones</a></span> </div> <div class="tags"> tags: </div> </div> </div> </div>

Paul I was going to make one of those but there is a shelf behind my lathe so no go ;)
Nice rack tool holder. :O)

Nice Rack. Thanks, Randy

Very neat rack. Well done Paul.

Great setup. I have one similar but not as well finished.
Another good job.

Barry