User Tag List

Results 1 to 10 of 16

Thread: Universal Grinding Fixture From Plans

Nov 8, 2018, 03:49 PM #1

jjr2001

Supporting Member

Join Date

Jun 2016

Posts

960

Thanks

1,194

Thanked 2,337 Times in 623 Posts

jjr2001's Tools

Awards Showcase

Total Awards: 10

Universal Grinding Fixture From Plans

Here are the plans by Doug Ross:
http://www.homemadetools.net/forum/u...9360#post89149

I wanted to make one a bit smaller so I used 2.5" diameter steel for the rotors.
Most of the other parts were made to fit this diameter.
Hot rolled steel was on hand so I used that for the rotors and cold rolled for the flat parts.

Very nice set of complete plans from Doug.
I did not put any numbers on the graduations yet and may do that after I make a stamping fixture.

The divisions are a little cramped with only a 2.5" diameter but are very readable. I think this is just
the ticket for sharpening and forming lathe tool bits.

Cheers, JR

Attached Thumbnails

300+ new builds daily: cars, trucks, bikes, fabrication → BuildThreads.com

Reply With Quote
The Following 11 Users Say Thank You to jjr2001 For This Useful Post:

emu roo (Apr 14, 2025), high-side (Nov 10, 2018), Home-PC (Dec 10, 2020), Jon (Nov 9, 2018), mwmkravchenko (Nov 9, 2018), philipUsesWood&Brass (Nov 12, 2018), PJs (Nov 11, 2018), rossbotics (Nov 9, 2018), Seedtick (Nov 9, 2018), tooly (Mar 12, 2019), UncleBob (Mar 12, 2019)