Advanced Crosscut Sled with an axle and a crank

**Paul Jones** · May 11, 2020, 07:02 PM

Very good design experiment using the prototype to prefect the version 2 design. Thank you for your You Tube voice overlay to the construction steps.

**Make Things** · May 23, 2020, 06:19 AM

Oh crap...I missed this comment! Thank you so much, I appreciate it! Sorry for the late reply.

**wizard69** · May 23, 2020, 11:26 AM

Originally Posted by Make Things

Oh crap...I missed this comment! Thank you so much, I appreciate it! Sorry for the late reply.

OH crap I missed this entire post!!!!!! Thank you very much for this innovative approach to a cross sled.

By the way, before I realized that you where building a prototype I wondered where you found a piece of construction timber flat and straight enough for a tool like this. That and I was thinking those little softwood components are going to split on you.

In any event most impressive with the final product!

**Make Things** · May 23, 2020, 03:50 PM

Originally Posted by wizard69

OH crap I missed this entire post!!!!!! Thank you very much for this innovative approach to a cross sled.

By the way, before I realized that you where building a prototype I wondered where you found a piece of construction timber flat and straight enough for a tool like this. That and I was thinking those little softwood components are going to split on you.

In any event most impressive with the final product!

��
Thank you. It's definitely a little different than most people's sleds, but I have too much clutter in my shop as it is...I needed something that would take up a few jigs as well as allow me to keep my blade at 90 degrees (I'm a prude to a blade that's a little off). Thanks for the compliment!