Angle Plates

**DIYer** · Sep 14, 2018, 07:20 AM

Thanks rossbotics! We've added your Angle Plates to our Measuring and Marking category,
as well as to your builder page: rossbotics's Homemade Tools. Your receipt:

Angle Plates by rossbotics

tags: angle, plate

**old_toolmaker** · Sep 15, 2018, 07:50 PM

rossbotics<

Like you, I use 4140 in many of my tools because of the high chrome content making them almost totally rust proof. I have some tools I made over 50 years ago and they look almost good as when newly made.

**rossbotics** · Sep 16, 2018, 08:34 PM

Yea I hear You
4140 and O-1 are probably my most two favorable metals to work with, their are others but those two are my first choice.

Originally Posted by old_toolmaker

rossbotics<

Like you, I use 4140 in many of my tools because of the high chrome content making them almost totally rust proof. I have some tools I made over 50 years ago and they look almost good as when newly made.

**old_toolmaker** · Sep 17, 2018, 09:21 AM

rossbotics,

When I was working for a living I used a lot of A-2 because we were always sending tool steel out for hardening. Now in my home shop I am too frugal to spend the money on outside heat treating so that is why I have gone to 4140 PH and O-1. I can easily harden the O-1 with a torch and oil quench. On an emergency basis, when I was still working, we used to heat treat A-2 with a torch and allow it to quench in still air. It also works.